[R-SIG-Mac] Minor bug in Quartz sizing

[Kasper Daniel Hansen]

This is what I have been saying as well.

My guess is that your "a centimeter above the screen edge) is because
of the Dock.  I have my Dock set to hiding and I get the window going
all the way down to the bottom of the screen.

In an earlier post I stated that I have not seen this on my 15"
Macbook Pro, presumably because the screen is bigger (I see it on my
old 13" Macbook).  If I do
  quartz(width = 10, height = 10)
on my 15", I get the same issue: the plot window is not square
(presumably because 10" is to high) and the plot is being cut off (R
is plotting as if the window was 10x10 but since the window is only
Yx10 we only see Y (with Y somewhat less than 10).).  For this
situation, I don't see the x-axis at all.

Kasper

On Tue, Sep 20, 2011 at 10:50 PM, Erich Neuwirth
<erich.neuwirth at univie.ac.at> wrote:
> OK,
> here is what really happens!
> When the quartz window is higher that the screen,
> the displayed windows does not extend below the screen, but it ends about a centimeter above the screen edge.
> The graphics is drawn as if the unmutilated larger windows were available.
> So the problem was I used
> quartz(height=7) and that is too high.
>
> quartz(height=6)
> solves the problem.
>
>
>
> -----BEGIN PGP SIGNATURE-----
>
> iEYEARECAAYFAk55GKgACgkQ+NXNFnPEeU9U7ACfZyn7OH+tjySGUBLV7EU4aAHR
> P3AAnjCnox72LJ6z9K+oNiJPLP/yhA2N
> =G4JH
> -----END PGP SIGNATURE-----
>
> _______________________________________________
> R-SIG-Mac mailing list
> R-SIG-Mac at r-project.org
> https://stat.ethz.ch/mailman/listinfo/r-sig-mac
>
>