[R] R 2.13.1 console echo problem or am I wrong?

ONKELINX, Thierry Thierry.ONKELINX at inbo.be
Wed Sep 14 17:03:16 CEST 2011

Have you tried adding print() statements? e.g. changing summary(x) to print(summary(x))

Posting a reproducible example would help us.

Best regards,


ir. Thierry Onkelinx
Instituut voor natuur- en bosonderzoek
team Biometrie & Kwaliteitszorg
Gaverstraat 4
9500 Geraardsbergen

Research Institute for Nature and Forest
team Biometrics & Quality Assurance
Gaverstraat 4
9500 Geraardsbergen

tel. + 32 54/436 185
Thierry.Onkelinx op inbo.be

To call in the statistician after the experiment is done may be no more than asking him to perform a post-mortem examination: he may be able to say what the experiment died of.
~ Sir Ronald Aylmer Fisher

The plural of anecdote is not data.
~ Roger Brinner

The combination of some data and an aching desire for an answer does not ensure that a reasonable answer can be extracted from a given body of data.
~ John Tukey

> -----Oorspronkelijk bericht-----
> Van: r-help-bounces op r-project.org [mailto:r-help-bounces op r-project.org]
> Namens Levent TERLEMEZ
> Verzonden: woensdag 14 september 2011 16:34
> Aan: r-help op r-project.org
> Onderwerp: [R] R 2.13.1 console echo problem or am I wrong?
> Dear Users,
> I was using 2.12.1 version for arules and arulesViz, but I encountered with a
> problem. I wrote a small function that can also plotting with arulesViz. The
> problem occures while plotting command is on, console does not print other
> commands' results. So I put off the plot command, but this time only the last
> command's result printed in the console and also <- operator did not put the
> result in the ls() output (all these commands run properly from console but I do
> not want to write everytime I need). First I thought that it was becaue of
> version, so uninstalled 2.12.1 and installed 2.13.1 but changed anything. The
> function code is below and I am using both Windows 7 and R in 64 Bit (32 Bit R
> did the same thing). I could not use R for a few years because of personal
> reasons, so I could not follow the changes if there are that I should.
> Thanks in advance for your replies.
> The Function:
> function()
> {
>     require(arules)
>     require(arulesViz)
>     veri<-read.transactions("c:/RVerileri/BitirmeVeri.csv",sep=";",col=1)    #After
> this, "veri" can not be seen in the ls() output
>     itemFrequencyPlot(veri,type="absolute")                                           #This works
> fine (if this command is deleted)
>     summary(veri)                                                                                #No output in
> console (No output in console)
>     itemFrequency(veri,type="absolute")                                                #No output in
> console (This works fine)
> }
> 	[[alternative HTML version deleted]]
> ______________________________________________
> R-help op r-project.org mailing list
> https://stat.ethz.ch/mailman/listinfo/r-help
> PLEASE do read the posting guide http://www.R-project.org/posting-guide.html
> and provide commented, minimal, self-contained, reproducible code.

More information about the R-help mailing list