[Rd] Non-vignette sweave file in package

[ONKELINX, Thierry]

Dear all,

I'm documenting an elaborate analysis as a private package. The package writes all required output to a database. I use a Sweave file to transform all the results from the database into a report.

Now I would like to add this Sweave to my package. I'm a bit puzzled on how to do that. It is not a vignette: the data is not available when the package is build and I need to recompile the Sweave file on demand (after the analysis was run).

So I have two questions.
1) Where to put a non-vignette Sweave file in a package.
2) How do I compile that Sweave file.

Best regards,

Thierry

ir. Thierry Onkelinx
Instituut voor natuur- en bosonderzoek / Research Institute for Nature and Forest
team Biometrie & Kwaliteitszorg / team Biometrics & Quality Assurance
Kliniekstraat 25
1070 Anderlecht
Belgium
+ 32 2 525 02 51
+ 32 54 43 61 85
Thierry.Onkelinx at inbo.be
www.inbo.be

To call in the statistician after the experiment is done may be no more than asking him to perform a post-mortem examination: he may be able to say what the experiment died of.
~ Sir Ronald Aylmer Fisher

The plural of anecdote is not data.
~ Roger Brinner

The combination of some data and an aching desire for an answer does not ensure that a reasonable answer can be extracted from a given body of data.
~ John Tukey

* * * * * * * * * * * * * D I S C L A I M E R * * * * * * * * * * * * *
Dit bericht en eventuele bijlagen geven enkel de visie van de schrijver weer en binden het INBO onder geen enkel beding, zolang dit bericht niet bevestigd is door een geldig ondertekend document.
The views expressed in this message and any annex are purely those of the writer and may not be regarded as stating an official position of INBO, as long as the message is not confirmed by a duly signed document.